&SURFACE Menu Tests
These are all simple tests of the &SURFACE Menu. In general, these get more complex as the number increases.

JACKUP:

This is a test of the ability use macros within the &surface menu.

BLOCK:

This is a test of the DIFFERENCE command ability to make a hole when the entire 2nd piece (cube2) intersects only on one face of the first piece (cube).

BLOCK2:

This is a test of the DIFFERENCE command ability to make a hole when the entire 2nd piece (cube2) intersects at the corner, three planes, of the first piece (cube).

BLOCK3:

This is a test of the UNION command ability to union two blocks that do not have a common space. This is also a test of the ability to DIFFERENCE the resulting unioned blocks out of a larger block.

BLOCK4:

This is a test of the UNION command ability to union several blocks that do not have a common space. This is also a test of the ability to DIFFERENCE the resulting unioned blocks out of a larger block.

BLOCK5:

This is a test of the UNION command ability to union several blocks of different sizes that do not have a common space. This is also a test of the ability to DIFFERENCE the resulting unioned blocks out of a larger block.